Cellular concrete thin-layer adhesive mortar white

9,52 / 25 kg inc. VAT, excl. shipping
(8,00 excl. VAT and shipping)
sol-adh-s
+
Add to wish list
  • Very good adhesion to concrete blocks
  • Easy to prepare
  • Rapid durability increase
  • Used in side connection systems
  • Long processing time

Preparation:

Stir the bag contents of 6-6.5 liters of pure water using a stirrer. After 5 minutes mix it again. Mortar prepared in this way is ready to use for about 4 hours. In case of partially binded mortar with water, it is unacceptable to mix it with water again. Ready-to-use mortar cannot be mixed with water or other dry mortar to change its consistency. The mortar should be applied on the cellular concrete blocks with a special trowel fitted to wall thickness or with the appropriate notched trowel. During mortar application it is essential to be aware that its surface on the blocks should be flat. Do not use in the traditional brickwork. The outdoor temperature at the time of application of the mortar should not be higher than 50 ˚ C. The mortar should be protected from direct sunlight and wind.

Efficiency:

From one 25kg bag it is possible to get 18l of ready to use mortar.

Consumption

BlocketFörbrukning
115 mm1,2 kg/m²
175 mm1,8 kg/m²
240 mm2,4 kg/m²
300 mm3,0 kg/m²
365 mm3,6 kg/m²
420 mm4,2 kg/m²
480 mm4,8 kg/m²

 

toller Beratung
Reklamation und Rückerstattung ohne Problemen
immer weiterempfehlen
Write a review

Also bought Also bought